Talking Busts Product Manual
​• When you first get the bust, open it by removing the front and back clips. You can turn on the sound module by flipping the on off switch shown in the picture. Be careful when flipping the switch, it is fragile and can break. If it does break it is still possible to flip it with a sharp object such as a knife tip.
​
• Press the button to play a quote or fun fact from the historical figure. Wait 1 second after the line ends so the module can reset, pressing it too quickly after a line is played will make the module lag and not play the next sound.
​
• Open the bust to reach the sound module. The sound module can be recharged. Make sure to turn the sound module off before recharging, otherwise it will not recharge properly. Glowing red LED means charging, no glowing means fully charged. This can take a few hours.
​
• You can use the USB-C cable to connect the module to a computer, treat it as a normal USB thumb drive. You delete the sound files inside or add new ones. The sound module has a built in randomizer, no sound file can be played in order.​
​
• To check the sound module for damage please refer to the following video. You can disassemble it from the housing. Use a small thin rod (for example a paper clip) to push out the button.